| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| BACK BRACING FOR 0 http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=8916 |
Page 1 of 1 |
| Author: | tippie53 [ Thu Oct 19, 2006 12:16 am ] |
| Post subject: | |
BRACE LOCATIONS FROM THE NECK EDGE TO THE FRONT OF THE BRACES 1ST BRACE 3.750 2ND 7.250 3RD 10.750 4TH 14.500 |
|
| Author: | LanceK [ Thu Oct 19, 2006 12:32 am ] |
| Post subject: | |
Thanks John! So, from the inside edge of the guitar side? NOT from the front of the neck block>? |
|
| Author: | TonyKarol [ Thu Oct 19, 2006 12:49 am ] |
| Post subject: | |
Not much diff from what I use on every guitar - from the neck/body joint, 4, 7.25, 10.75, 14.75. |
|
| Author: | tippie53 [ Thu Oct 19, 2006 4:01 am ] |
| Post subject: | |
This is from the "Front" of the guitar. If you are off the thickness of the side set that isn't going to make any difference. The spec of the bracing is ols style # 1 & 2 .250 by .625 # 3 $ 5 .750 by .250 ( rounded like a broom handle ) New style 1 & 2 same 3 $ 4 .380 by .750 both at a 20 foot radius There ya go john |
|
| Author: | LanceK [ Thu Oct 19, 2006 4:07 am ] |
| Post subject: | |
Thanks John! |
|
| Author: | tippie53 [ Thu Oct 19, 2006 5:14 am ] |
| Post subject: | |
you are all welcome |
|
| Author: | Anthony Z [ Thu Oct 19, 2006 6:00 am ] |
| Post subject: | |
John thank you very much! I really appreciate the info. Lance good luck with your "O". What will you be using for the back/top of yours? I've got some really nice quilted maple and a Sitka top for mine and will probably use birdseye or curly maple for the neck. |
|
| Author: | John Lewis [ Thu Oct 19, 2006 10:09 am ] |
| Post subject: | |
Thanks John! It's nice to have this along with the body and side templates. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|